Grass Valley Jupiter v.1.1.0 - Manual (Page 44)

36 JUPITER AccuSwitch Soft Panels and Visual Status Display Instruction Manual
Section 3 — Multi-Level XY Soft Panel
Figure 36. Source Entry Section
Selecting the source entry will load the source name in the Preset row.
The
Take button will then be enabled.
4. Click the Take button.
The newly switched source will now be shown in the Status row
(
Figure 37 ).
Figure 37. Status Row
Advise Option
When the Advise flag option has been set in the Jupiter Control system and
an attempt is made to switch a Source to a new Destination, the switch will
not occur. The Multi-Level XY panels will instead display the following
message on the control panel:
SRC in use by:
This message will be displayed for approximately three (3) seconds and
will then disappear.
You will not be able to switch to a new device will not be executed until the
destination that is using the source is either:
• Switched to a different source.
• Switched to the “SAFE” input.
Note The Advise option will not work when you are using Sequences or Multiple-
destination switching when the same source is being routed to more than one
destination.