Source selection (all levels take) – Grass Valley Jupiter v.1.1.0 User Manual
Page 43
JUPITER AccuSwitch Soft Panels and Visual Status Display Instruction Manual
35
Multi-Level XY Soft Panel Operating Procedures
Note
Panels will show eight asterisks (****) as a status, when the panel has no
way of reporting the mnemonic of the source. This condition could occur
when a source that is selected by panel “B” has the same destination that is
being statused by Panel “A,” and this source is not available in the configu-
ration for panel “A.”
Panels that cannot be changed to the desired destination may have been
restricted to certain destinations by the CP Output set that is used on the
Jupiter MPK Devices table.
Source Selection (All Levels Take)
To select a source:
1.
Check that the desired destination is shown in the Destination window,
which is located in the lower left-hand corner of the interface.
Figure 34. Destination Window
2.
Select the desired source category; VCR is used in the example below
(
). This selection will populate the Source Entries fields with
the available sources in the selected category.
Figure 35. Source Category Section
3.
Choose a source entry; SRC-072 is used in the example below (
).