Grass Valley Jupiter v.1.1.0 - Manual (Page 36)

28 JUPITER AccuSwitch Soft Panels and Visual Status Display Instruction Manual
Section 2 — Basic XY Soft Panel
Figure 28. Status Window
Advise Option
When the Advise flag option has been set in the Jupiter Control system and
an attempt is made to switch a Source to a new Destination, the switch will
not occur. The Basic XY panels will instead display the following message
on the control panel:
SRC in use by:
This message will be displayed for approximately three (3) seconds and
will then disappear.
You will not be able to switch to a new device until the destination that is
using the source is either:
• Switched to a different source.
• Switched to the “SAFE” input.
Note The Advise option will not work when you are using Sequences or Multiple-
destination switching when the same source is being routed to more than one
destination.
This option will avoid having the Source connected to two Destinations at
the same time.
Swap/Undo
After each switch, the previous source will automatically return to the
Preset display so that each “
Take” will make the last two sources to “flip-
flop.” (The Preset display will be cleared when a new source or destination
is selected.)