Grass Valley Jupiter v.1.1.0 User Manual
Page 17
JUPITER AccuSwitch Soft Panels and Visual Status Display Instruction Manual
9
Configuration
Note
Currently, the only selectable option for the Protocol list is ES-LAN.
Figure 9. Router Connection Editor Dialog
Controller network Settings
1.
Enter the IP address of the AccuSwitch Controller that is associated
with this Soft Panel in the Primary IP Address field.
2.
Enter the IP address of the secondary AccuSwitch Controller in the
Secondary IP Address field. Leave the field blank if there is not a
secondary controller.
3.
Enter a number between 1 and 64 for the Device ID field. This number
must be unique from all panels that are associated with the same
AccuSwitch Controller. The Device ID is also entered on the MPK
Devices table, as described below in the
section.
Note
The Device ID number selected here corresponds to the MPK table Address
entry that uses two digit leading-zero numbers (01-09).
4.
Select the IP address for the PCs NIC card from the PC IP Address drop-
down list, if it is not already selected (See Soft Panel PC IP Settings
Note
If you have more than one NIC card, consult your IT department to determine
which IP Address will be able to communicate with the Jupiter Network
(AccuSwitch control board).
5.
Click the
Connect
button.