Source and destination paging buttons, Source selection (all levels take) – Grass Valley Jupiter v.1.1.0 User Manual
Page 34
26
JUPITER AccuSwitch Soft Panels and Visual Status Display Instruction Manual
Section 2 — Basic XY Soft Panel
Note
Panels will show eight asterisks (****) as a status, when the panel has no
way of reporting the mnemonic of the source. This condition could occur
when a source that is selected by panel “B” has the same destination that is
being “statused” by Panel “A,” and this source is not available in the config-
uration for panel “A.”
When a panel cannot be changed to the desired output, the panel may have
been limited to certain outputs by the CP Output set used on the Jupiter
MPK Devices table.
Source and Destination Paging Buttons
The Source and Destination
Paging
buttons are used to scroll through and to
see the destinations and the source panel’s options. Sometimes, all of these
destination and source options cannot fit on the screen. The “paging”
buttons will be active when there are options that are “off screen”, if not,
they will be grayed out.
description of what the button will do when it is clicked.
Source Selection (All Levels Take)
Note
The Basic XY application does not allow switching levels independently.
Follow these steps to make a Source selection:
1.
Check that the desired destination has been selected.
Table 4. The Paging Buttons
The Start button: Clicking this button will show the beginning
options on the “list.”
The Previous button: Clicking this button will show the pre-
ceding options.
The Next button: Clicking this button will show the succeed-
ing options.
The End button: Clicking this button will show the last options
on the “list.”
Page Indicator: Displays what page is being displayed for the
Destination Categories, Source Categories, Destination
Entries, and Source Entries sections (For example, page 1 of
2.).