Using the force unlock option, Clearing tie lines – Grass Valley Jupiter v.1.1.0 User Manual
Page 100
90
JUPITER AccuSwitch Soft Panels and Visual Status Display Instruction Manual
Section 6 — VSD Procedures
3.
Click the
OK
button.
The Zoom percentage will then be applied.
Using the Force Unlock Option
The VSD can force unlock any destination regardless of what panel locked
or protected it. In order for Force Unlock to be enabled, the VSD must be
defined with a password of 90 – 99 in MPK Devices table of the Jupiter
Editor. The
Force Unlock
button will only be enabled if the password is set to
90-99 and a locked/protected cell has been selected.
Note
If AccuSwitch or Jupiter locks or protects a Destination on a 3rd party router
that is shared with another control system, there is the possibility that after a
pmemClear command occurs on the AccuSwitch/Jupiter Control system that
the destination will report as being locked or protected by the 3rd party’s
control system. This Destination will have to be Force unlocked by an AccuS-
witch/Jupiter Control system with Force Unlock privileges to regain control
of the Destination.
Follow these steps to use the Force Unlock option:
1.
Select the Locked cells (
Figure 100. Selected Tie Line
2.
Click the
Force unlock
button.
The destinations will no longer be locked.
Clearing Tie Lines
Tie Lines or the connections between routers can be replaced using the
Clear
Selected Tie Lines
button (
Selected
Locked Cells