H3C Technologies H3C SecPath F1000-E - Manual (Page 90)

82
# Configure the firewall to shut down GigabitEthernet 0/3 at 18:00 on working days every week.
[SecPath-job-pc3] time 2 repeating at 18:00 week-day mon tue wed thu fri command shutdown
[SecPath-job-pc3] quit
# Display information about scheduled tasks.
[SecPath] display job
Job name: pc1
Specified view: GigabitEthernet0/1
Time 1: Execute command undo shutdown at 08:00 Mondays Tuesdays Wednesdays Thursdays
Fridays
Time 2: Execute command shutdown at 18:00 Mondays Tuesdays Wednesdays Thursdays Fridays
Job name: pc2
Specified view: GigabitEthernet0/2
Time 1: Execute command undo shutdown at 08:00 Mondays Tuesdays Wednesdays Thursdays
Fridays
Time 2: Execute command shutdown at 18:00 Mondays Tuesdays Wednesdays Thursdays Fridays
Job name: pc3
Specified view: GigabitEthernet0/3
Time 1: Execute command undo shutdown at 08:00 Mondays Tuesdays Wednesdays Thursdays
Fridays
Time 2: Execute command shutdown at 18:00 Mondays Tuesdays Wednesdays Thursdays Fridays
Setting the port status detection timer
Some protocols might shut down ports under specific circumstances. For example, MSTP shuts down a
BPDU guard–enabled port when the port receives a BPDU. In this case, you can set the port status
detection timer. If the port is still down when the detection timer expires, the protocol module
automatically cancels the shutdown action and restores the port to its original physical status.
To configure the port status detection timer:
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure the port status
detection timer.
shutdown-interval time
Optional.
By default, the detection timer is 30
seconds.
Setting the temperature thresholds for a card
You can set the temperature alarm thresholds to monitor the temperature of a card. When the
temperature of a card reaches the threshold, the firewall generates alarms.
To set the temperature thresholds for a card:
Step Command Remarks
1. Enter system view. system-view N/A