beautypg.com

Login overview, Feature and hardware compatibility, Login methods at a glance – H3C Technologies H3C SecPath F1000-E User Manual

Page 19

background image

11

Login overview

Feature and hardware compatibility

Feature F1000-A-EI/E-SI/S-AI

F1000-E

F5000-A5 Firewall

module

FIPS No

No

No

Yes

Login methods at a glance

Login method

Default state

Logging in to the CLI

:

Logging in through the console port

By default, login through the console port is enabled, no username or
password is required, and the user privilege level is 3.

Logging in through Telnet

By default, you can log in to a device through Telnet with the IP
address 192.168.0.1/24 (the IP address of the management
interface GigabitEthernet 0/0), login username admin, password

admin, and user privilege level 3.

Logging in through SSH

By default, SSH is disabled. To use SSH service, complete the
following configuration tasks:

Enable the SSH function and configure SSH attributes.

Assign an IP address to the device's management interface and

configure routes to make sure the interface and the SSH client can

reach each other.

Enable scheme authentication for VTY login users.

Configure the user privilege level of VTY login users (0 by default).

Logging in to the Web interface

By default, you can log in to a device through Web with the IP address
192.168.0.1/24 (IP address of the management interface

GigabitEthernet 0/0), username admin, and password admin.

Logging in through SNMP

By default, SNMP login is disabled. To use SNMP service, complete
the following configuration tasks:

Assign an IP address to the device’s management interface, and

configure routes to make sure the interface and the NMS can reach

each other.

Configure SNMP basic parameters..

Logging in to the firewall module from
the network device

After configuring the network device and the firewall module properly,
you can log in to the firewall module from the network device.