H3C Technologies H3C SecPath F1000-E User Manual
Page 66

58
Figure 37 Basic configuration wizard—3/6 (service management)
2.
Configure services as described in
.
Table 9 Configuration items
Item Description
FTP
Specify whether to enable FTP on the firewall.
Disabled by default.
Telnet
Specify whether to enable telnet on the firewall.
Disabled by default.
HTTP
Specify whether to enable HTTP on the firewall, and set the HTTP port number.
Enabled by default.
IMPORTANT:
•
If the current user has logged in to the web interface through HTTP, disabling HTTP
or modifying the HTTP port number will result in disconnection with the firewall.
Therefore, perform the operation with caution.
•
When you modify a port number, make sure that the port number is not used by
another service.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS