H3C Technologies H3C SecPath F1000-E - Manual (Page 34)

26
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable display of copyright
information.
copyright-info enable
Optional.
Enabled by default.
3. Enter one or multiple VTY user
interface views. user-interface vty first-number
[ last-number ]
N/A
4. Enable the terminal service shell
Optional.
Enabled by default.
5. Enable the current user
interface(s) to support either
Telnet, SSH, or both of them
protocol inbound { all | ssh |
telnet }
Optional.
By default, both protocols are
supported.
The configuration takes effect next
time you log in.
6. Define a shortcut key for
terminating tasks escape-key { default |
character }
Optional.
By default, you can press Ctrl+C to
terminate a task.
7. Configure the type of terminal
display
terminal type { ansi | vt100 }
Optional.
By default, the terminal display
type is ANSI.
8. Set the maximum number of lines
on the next screen
screen-length screen-length
Optional.
By default, the next screen displays
24 lines.
A value of 0 disables the function.
9. Set the size of history command
buffer history-command max-size
value
Optional.
By default, the buffer saves 10
history commands.
10. Set the idle-timeout timer idle-timeout minutes [ seconds ]
Optional.
The default idle-timeout is 10
minutes for all user interfaces.
The system automatically
terminates the user’s connection if
there is no information interaction
between the device and the user in
timeout time.
Setting idle-timeout to 0 disables
the timer.