Configuring the maximum number of concurrent users, Configuring the exception handling method, Rebooting the firewall – H3C Technologies H3C SecPath F1000-E User Manual
Page 84

76
Step Command
Remarks
6.
Configure the MOTD banner. header motd text Optional
Configuring the maximum number of concurrent
users
You can limit the number of users that can perform operation in system view simultaneously. When
multiple users configure a setting in system view, only the last configuration applies.
When the number of concurrent users reaches the upper limit, other users cannot enter system view.
To configure the maximum number of users that can enter system view simultaneously:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the maximum
number of concurrent users.
configure-user count number
Optional.
By default, up to two users are
allowed to perform operations in
system view at the same time.
Configuring the exception handling method
The firewall supports the following software exception handling methods:
•
reboot—The firewall automatically reboots to recover from the error condition.
•
maintain—The firewall stays in the error condition so you can collect complete data, including error
messages, for diagnosis. In this approach, you must manually reboot the firewall.
When multiple users configure a setting in system view, only the last configuration applies.
When the maximum number of concurrent users is reached, other users cannot enter system view.
To configure the exception handling method:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the exception
handling method.
system-failure { maintain | reboot }
Optional.
By default, the system reboots
when an exception occurs.
Rebooting the firewall
This section describes how to reboot the firewall.
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS