Enabling displaying the copyright statement, Configuring banners, Banner message input modes – H3C Technologies H3C SecPath F1000-E User Manual
Page 82

74
Step Command
Remarks
2.
Enter user interface view.
user-interface { first-num1
[ last-num1 ] | { console | vty }
first-num2 [ last-num2 ] }
N/A
3.
Set the idle timeout timer.
idle-timeout minutes [ seconds ]
10 minutes by default
Enabling displaying the copyright statement
The firewall by default displays the copyright statement when a Telnet or SSH user logs in, or when a
console user quits user view. You can disable or enable the function as needed. The following is a sample
copyright statement:
**************************************************************************
* Copyright (c) 2004-2011 Hangzhou H3C Tech. Co., Ltd. All rights reserved.*
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
**************************************************************************
To enable displaying the copyright statement:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable displaying the
copyright statement.
copyright-info enable
Optional.
Enabled by default.
Configuring banners
Banners are messages that the system displays during user login.
The system supports the following banners:
•
Legal banner—Appears after the copyright or license statement. To continue login, the user must
enter Y or press Enter. To quit the process, the user must enter N. Y and N are case-insensitive.
•
Message of the Day (MOTD) banner—Appears after the legal banner and before the login banner.
•
Login banner—Appears only when password or scheme authentication has been configured.
•
Incoming banner—Appears for Modem users.
•
Shell banner—Appears for non-Modem users.
Banner message input modes
You can configure a banner in one of the following ways:
•
Single-line input:
Input the entire banner in the same line as the command. The start and end delimiters for the
banner must be the same but can be any visible character. The input text, including the command
keywords and the delimiters cannot exceed 510 characters. In this mode, do not press Enter
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS