H3C Technologies H3C WA2600 Series WLAN Access Points - Manual (Page 54)

7-32
Validating file. Please wait.........................
Configuration is saved to device successfully.
After modifying the user password, use the save command to save it.
BootWare Password Loss
Contact your local dealer if you forget the BootWare password. The technical support staff will help you
log in to the access controller and set a new password.
To change the BootWare password, enter the BootWare main menu, select 5, and follow the prompts:
please input old password:
Please input new password:
Please input new password again:
Password Set Successfully.
z If you enter a wrong old password, the system prompts “Wrong password,Please input password
again”.
z If you fail to input a correct password within three attempts, the system prompts “Wrong
password,system halt”.
z An input BootWare password is displayed as “*”.
z The BootWare password can consist of a maximum of 32 printable characters, including letters,
numerals, and symbols. If you input a password longer than 32 characters, the system
automatically uses the first 32 characters as the password.
Super Password Loss
The super password enables you to switch between four super levels. If you forget the super password,
you will be unable to perform some higher privilege operations.
Follow these steps to bypass the super password:
1) Select 8 from the BootWare main menu.
======================================================
|<1> Boot System |
|<2> Enter Serial SubMenu |
|<3> Enter Ethernet SubMenu |
|<4> File Control |
|<5> Modify BootWare Password |
|<6> Skip Current System Configuration |
|<7> BootWare Operation Menu |