beautypg.com

Factory default configuration, Factory default configuration of a fat ap, Removing the factory default configuration – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual

Page 29

background image

7-7

| <3> Set The Default Boot Device |

| <0> Exit To Main Menu |

=============================================================

Enter your choice(0-3):

Factory Default Configuration

The factory default configuration is the default configuration of the device at system boot before any

settings are made to the device. The factory default configuration enables you to use all the basic

functions upon AP power-on.

z

If you perform configurations and save the configurations on the AP, the AP uses the configuration

file you have saved for next startup.

z

If you remove the current configuration file, namely, no configuration file exists on the AP, the AP

starts with the factory default configuration upon next startup.

z

If you disable the AP from booting with the default configuration (see

Removing the Factory Default

Configuration

), it boots with null configuration.

z

The filename you specified when saving the configuration file is used as the configuration filename

for next startup. This startup mode is prior to the startup with the factory default configuration.

z

If no configuration file exists on the Flash of the AP, it boots with the factory default configuration.

The factory default configuration is set by the vendor of the AP, and you cannot modify it.

Factory Default Configuration of a Fat AP

z

For the factory default configuration of a fat AP, see

Configuring Basic Functions for an AP

Operating in Fat Mode

.

z

A fit AP has zero configuration. All the configuration and management are performed by ACs or

USs.

Removing the Factory Default Configuration

Upon AP boot, when the prompt “Press Ctrl+B to enter extended boot menu...” appears, press Ctrl+B.

The system prompts you to enter the BootWare password:

Please input BootWare password:

After you provide the correct password, the system enters the BootWare main menu (the initial

BootWare password is null, and you can directly press Enter):

======================================================

|<1> Boot System |

|<2> Enter Serial SubMenu |

|<3> Enter Ethernet SubMenu |

|<4> File Control |

|<5> Modify BootWare Password |

|<6> Skip Current System Configuration |

This manual is related to the following products: