Set up an upgrade environment – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual
Page 43
7-21
# Upload application file wa2200_fat.bin on the AP to the PC, and save it as wa2200_fat.bin.
[ftp]put wa2200_fat.bin
227 Entering passive mode (192,168, 0,1,5,34)
125 Using existing data connection
...............................................226 Closing data connection; File transfer
successful.
FTP: 7884208 byte(s) sent in 271.703 second(s), 29.00Kbyte(s)/sec
[ftp]quit
221 Service closing control connection
z
When you back up an application, if the file name already exists on the AP, the system does not
output any information, but directly overwrites the existing file.
z
For information about the tftp command, see FTP and TFTP in the Fundamentals Command
Reference in the H3C WA Series WLAN Access Points Command References.
z
To back up a configuration file, use the same method.
Table 7-6 Output description of commands for application upgrade and backup when the AP serves as
the FTP client
Output
Description
[ftp]get wa2200_fat.bin wa2200_fat.bin
Download the file to be upgraded from the FTP server.
flash:/wa2200_fat.bin has been existing.
Overwrite it? [Y/N]:
Prompt you whether to overwrite the file with the same
name.
FTP: 7884208 byte(s) received in 271.703
second(s), 29.00K byte(s)/sec.
The file is downloaded and upgraded.
[ftp] put wa2200_fat.bin wa2200_fat.bin
Upload the file from the AP to the FTP server for backup.
FTP: 7884208 byte(s) sent in 271.703 second(s),
29.00Kbyte(s)/sec
The file is uploaded and backed up.
[ftp]quit
Exit FTP client view.
221 Service closing control connection
Close the service control connection.
Upgrading an Application by Using FTP with the Default Configuration
This function is applicable to the case that an application is deleted completely and a new application
needs to be downloaded. For this approach of upgrading an application, the working mode of the AP
must be fat AP.
Set up an upgrade environment
Set up an upgrade environment as shown in
and
Enable FTP server on the PC and set the path where the application file is stored.