3 installation preparations, Installation preparations, Preparing installation tools – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual
Page 10
3-1
3
Installation Preparations
This chapter describes the preparations for installing WA series WLAN access points, including the
preparation of installation tools and environment examination.
The installation preparations for the H3C WA series access points depend on the installation
environments (indoor or outdoor). For more information about the installation preparations of an AP
model, see the installation guide or quick start of the AP.
Installation Preparations
Before installing your AP:
z
Power on your AP, and connect it to an Ethernet. Check the corresponding LED status on your AP,
and make sure that your AP works normally.
z
Save the installation position, MAC address, and serial number of your AP, to facilitate the
management and maintenance of APs by administrators.
z
Determine whether installation accessories (for example, or power adapter) are needed according
to the installation position and power supply mode of your AP. Order them in advance because
some installation accessories are not shipped with your AP, and you need to purchase them
yourself.
Preparing Installation Tools
When installing the AP, you may need the tools listed in
. Choose the appropriate tools
according to the installation environment.
Table 3-1 List of installation tools
Type of tool
Indoor installation
outdoor installation
General tools
1-meter-long rulers, marking pens, knives, a
percussion drill with appropriate bits, screw
driver, and adjustable spanner
Digging tool, adjustable spanner, vices, and
screw driver
Special tools
Cable strippers, crimping pliers, and RJ-45
crimping pliers
Cable stripper, crimping pliers, RJ-45
crimping pliers, waterproof tape, and fiber
fusion splicer
Auxiliary tools
Ladders and rubber hammers
Ladders