Upgrading an application through the web interface, Displaying file list – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual
Page 45
7-23
Table 7-7 Description on the display information of setting Ethernet interface parameters
Parameter
Description
Protocol (FTP or TFTP)
Downloading flag
Load File Name
Name of the file to be loaded
Target File Name
Target file name. Name of the file to be downloaded
from the TFTP or FTP server.
Server IP Address
IP address of the TFTP or FTP server
Local IP Address
Default IP address of the AP
Gateway IP Address
Gateway IP address, no need to set.
FTP User Name
Default FTP username
FTP User Password
Default password of the FTP user
# Upon successful download, the application is automatically upgraded.
Updating File flash:/wa2200_fat.bin.........................................
........................Done!
# The upgrade is completed, and the system starts up automatically.
System is starting...
Upgrading an Application Through the Web Interface
Take a WA2200 series as an example to complete application upgrade. Select Device > File Manage
from the navigation tree to enter the file management page, as shown in
Displaying File List
On the top of the page, if you select a disk (APs support only flash at present) from the drop-down list,
the used space, free space, and total capacity of the disk will be displayed at the right of the drop-down
list, and all files saved in this disk (displayed in the format of path + filename) and their sizes will be in
the list below the drop-down list.