beautypg.com

Specifying an ip address for an ap, Configuring wlan service – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual

Page 19

background image

6-4

Specifying an IP Address for an AP

Follow these steps to specify an IP address for the AP:

To do…

Use the command…

Remarks

Enter system view

system-view

Create VLANs

vlan vlan-id1 [ to vlan-id2 ]

Optional

Using this command can create multiple VLANs
in batches.

Create a VLAN
interface and enter
VLAN interface view

interface vlan-interface
vlan-interface-id

Required

z

If the VLAN interface already exists, you enter
its view directly.

z

If the VLAN interface does not exist, you need
to create a VLAN and then enter VLAN
interface view.

Assign an IP address
to the VLAN interface

ip address ip-address { mask |
mask-length
}

Required

IP address 192.168.0.50 is assigned to
VLAN-interface 1 by default. No IP address is
configured for other VLAN interfaces.

Configure the
description of the
current VLAN

description text

Optional

VLAN interface name is used by default, for
example, Vlan-interface1 Interface.

Bring up the VLAN
interface

undo shutdown

Optional

By default, a VLAN interface is in the up state. In
this case, the VLAN interface is up so long as one
port in the VLAN is up and goes down if all ports
in the VLAN go down.

An administratively shut down VLAN interface
however will be in the down state until you bring it
up, regardless of how the state of the ports in the
VLAN changes.

Configuring WLAN Service

WLAN service configuration includes WLAN global configuration, country code, service template, and

radio configuration.

Follow these steps to configure WLAN service:

To do…

Use the command…

Remarks

Enter system view

system-view

Configure global WLAN parameters

Specifies the time for which the link
between AP and client
( power-save or awake ) can be
idle

wlan client idle-timeout
interval

Optional

By default, the idle timeout interval is 3600
seconds.

Configure the keep alive timeout
interval for the device

wlan client keep-alive
interval

Optional

By default, keep alive function is disabled.

Enable the fat AP to respond to the
probe requests with the SSID null
sent by the client

wlan broadcast-probe
reply

Optional.

By default, . the fat AP respond the probe
requests with the SSID null sent by the
client.

This manual is related to the following products: