6 configuring basic functions, Configuring basic functions – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual
Page 16
6-1
6
Configuring Basic Functions
The WA series WLAN access points, except the WA2110-AG that can only operate in fit mode, can
operate in both fat and fit modes, and you can switch the operating mode of an AP as needed.
Configuring Basic Functions for an AP Operating in Fit Mode
An AP operating in fit mode has zero configuration. When it is associated with an access controller (AC)
or unified switch (US), it does not need or save any configuration. All configurations are performed on
the AC or US.
Configuring Basic Functions for an AP Operating in Fat Mode
An AP operating in fat mode has the default configuration as follows:
The default output depends on your AP model.
#
version 5.20, Release 1104P01
#
sysname WA2612-AGN
#
domain default enable system
#
telnet server enable
#
port-security enable
#
vlan 1
#
domain system
access-limit disable
state active
idle-cut disable
self-service-url disable
#
user-group system
#
local-user admin
password simple h3capadmin
authorization-attribute level 3