Restart the ac or us, Maintaining application and configuration files – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual
Page 50
7-28
z
Before upgrade, ensure the consistency of the application versions of the AP and the AC or US;
otherwise, the AP cannot work normally.
z
On the AC or US, you can use the wlan apdb model-name hardware-version software-version
command to set the matrix between AP version and AC (or US) version. For more information, see
WLAN Service in the WLAN Command Reference in the H3C WA Series WLAN Access Points
Command References.
Restart the AC or US
After AP application download and AC or US application upgrade, restart the AC or US:
Start to check configuration with next startup configuration file, please wait.
........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
After AC or US reboot, all the APs associated with it will finish application upgrade and reboot
automatically.
z
Automatic AP upgrade results in service interruption. Therefore, perform automatic upgrade when
appropriate.
z
By default, when the AP is being automatically upgrade, the AC or US does not give any prompt.
z
If the AP cannot work normally as a result of automatic upgrade, check whether the AP version is
consistent with the AC or US version. If not, you can download the AP application to upgrade the
AP, without restarting the AC or US.
Maintaining Application and Configuration Files
You can use the file control submenu to display delete file types.
Take a WA2200 series as an example. Select 4 from the BootWare main menu to enter the file control
submenu. The following information appears:
===============================
|Note:the operating device is flash |
|<1> Display All File(s) |
|<2> Set Application File type |
|<3> Delete File |
|<0> Exit To Main Menu |
==========================================================================
Enter your choice(0-3):