Switching the working mode at the cli, Set the working mode to fit ap – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual
Page 32
7-10
|Note:the operating device is flash |
|<1> Display All File(s) |
|<2> Set Application File type |
|<3> Delete File |
|<0> Exit To Main Menu |
==========================================================================
Enter your choice(0-3): 1
Display all file(s) in flash:
'M' = MAIN 'B' = BACKUP 'S' = SECURE 'N/A' = NOT ASSIGNED
==========================================================================
|NO. Size(B) Time Type Name |
|1 7884208 Aug/08/2008 20:00:00 N/A wa2200_fat.bin |
|2 428 Apr/26/2000 12:00:34 N/A private-data.txt |
|3 3923104 Apr/26/2000 12:11:16 M+B wa2200_fit.bin |
==========================================================================
If you modify the main application file name by using the rename command, the system cannot be
started. For more information about the rename command, see SSH2.0 in the Security Command
Reference in the H3C WA Series WLAN Access Points Command References.
Switching the Working Mode at the CLI
Set the working mode to fit AP
To set the working mode of the AP working in the fat mode to the fit mode, use the boot-loader file
file-url { main | backup } command:
On a WA2200 series:
This command will set the boot file. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 1!