beautypg.com

H3C Technologies H3C WA2600 Series WLAN Access Points User Manual

Page 18

background image

6-3

Field

Description

domain system

access-limit disable

state active

idle-cut disable

self-service-url disable

Basic configurations in the default domain system:

The number of associated clients is not limited.

Specify the current domain to be in the active state.

Disable the idle-cut function for the current ISP domain.

Disable the location function of the self-service server.

user-group system

system is the default user group. You cannot delete the
default user group but you can modify its configuration.

local-user admin

password simple h3capadmin

authorization-attribute level 3

service-type telnet

The default configuration of the local user is as follows:

z

The username is admin.

z

The password is h3capadmin, case sensitive.

z

The user level is 3 (manage level).

z

The service type is telnet.

wlan rrm

dot11a mandatory-rate 6 12 24

dot11a supported-rate 9 18 36 48 54

dot11b mandatory-rate 1 2

dot11b supported-rate 5.5 11

dot11g mandatory-rate 1 2 5.5 11

dot11g supported-rate 6 9 12 18 24 36 48 54

The default 802.11a/b/g settings are as shown on the
left column.

The default rates depend on your AP model.

wlan service-template 1 clear

ssid H3C

service-template enable

By default, service template 1 with the authentication
mode open system and SSID H3C is configured on the
AP.

interface NULL0

The interface type supported by the AP.

interface Vlan-interface1

ip address 192.168.0.50 255.255.255.0

By default, the default IP address of VLAN-interface 1 is
192.168.0.50, and the subnet mask is 255.255.255.0.

interface GigabitEthernet1/0/1

The interface type supported by the AP.

interface WLAN-BSS32

port link-type hybrid

port hybrid vlan 1 untagged

By default, WLAN-BSS32 is a hybrid port, and removes
VLAN tags before forwarding packets from VLAN 1.

interface WLAN-Radio1/0/1

service-template 1 interface wlan-bss 32

By default, service template 1 is associated with radio
interface WLAN BSS 32.

load xml-configuration

The AP loads the configuration file with extension .xml
after startup.

user-interface con 0

user-interface vty 0 4

authentication-mode scheme

The AP supports console and VTY user interfaces. By
default, the authentication mode for VTY login is AAA.

Besides the default configurations, you need to perform the following configurations to use a fat AP in

your network:

z

Specifying an IP Address for an AP

z

Configuring WLAN Service

z

Saving the Current Configuration

This manual is related to the following products: