Replacing a transceiver module – H3C Technologies H3C SR6600 User Manual
Page 84
74
To replace a CF card:
1.
Make sure the CF card LED is not flashing. A flashing CF card LED means that the system is
accessing the CF card.
To replace the CF card on the MCP, remove the CF card cover first.
2.
, press the CF card eject button of the CF card reader so that the eject button
protects from the panel.
Figure 77 Pressing the eject button
3.
Press the eject button again to eject the CF card part-way out of the CF card reader, and then pull
the CF card out of the CF card reader.
Figure 78 Pressing the eject button to eject the CF card
4.
Install a new CF card. For more information, see "
."
To protect the CF card, place it into an antistatic bag.
Replacing a transceiver module
WARNING!
•
Do not stare into the optical fibers.
•
When removing a transceiver module, do not touch the golden finger of the transceiver module.
To replace a transceiver module:
1.
Remove the optical fibers from the transceiver module.
2.
Pivot the clasp down to the horizontal position.
3.
As shown in
, holding the handle of the transceiver module, gently pull the transceiver
module out.