H3C Technologies H3C SR6600 - Manual (Page 34)

24
1. Make sure the power is OFF.
2. Remove the protection cover of the DC power module.
3. Connect the end marked with "– "to the negative terminal (–) on the power module and fasten the
screw.
4. Connect the end marked with "+"to the positive terminal (+) on the power module and fasten the
screw.
5. Connect the other end of the DC power cord to the DC power source.
6. Install the protection cover of the DC power module.
Figure 24 Connecting the DC power cord
Connecting the power cord for the PSR1200-D
Figure 25 DC power cord
To connect the DC power cord:
1. Loose the captive screws on the power module with a Phillips screwdriver to remove the power
module connector.
2. Connect the end marked with "– "to the negative terminal (–) on the power module and fasten the
screw.
3. Connect the end marked with "+"to the positive terminal (+) on the power module and fasten the
screw.
-
+