H3C Technologies H3C SR6600 - Manual (Page 25)

15
Figure 10 Internal structure of the RPE-X1 carrier
Figure 11 Installing the RPE-X1 carrier
4. Gently push the RPE-X1 carrier (with the components facing up) into slot 1 along the slide rails until
the positioning pins on the backplane are seated in the positioning holes at the bottom of the
RPE-X1 carrier. Then push the ejector levers inward to lock the RPE-X1 carrier in position and fasten
the captive screws on the ejector levers.
Figure 12 Inserting the RPE-X1 into the slot
5. Use even pressure to gently push the RPE-X1 into slot 1 along the slide rails, and then push the
ejector levers inward to lock the board in position.