beautypg.com

Replacing an mcp – H3C Technologies H3C SR6600 User Manual

Page 80

background image

70

Figure 71 Pulling the RSE-X1 MPU out of the slot

4.

If you do not install a new MPU in the slot, install a blank panel. To install a new MPU, see
"

Installing an RSE-X1 MPU

."

Replacing an MCP

To replace an MCP, for example, MCP-X1:

1.

Determine the MCP to be removed. This section takes the MCP in slot 1 as an example.

2.

Use a Phillips screwdriver to loosen the captive screws on the MCP to be removed until all spring
pressure is released.

3.

Holding the ejector levers of the MCP with both hands, pull the ejector levers outward, and gently
pull the MCP out of the slot along the slide rails.

Figure 72 Pulling the MCP out of the slot

See also other documents in the category H3C Technologies Routers: