H3C Technologies H3C SR6600 - Manual (Page 32)

22
3. Use a Phillips screwdriver to fasten the captive screws on the fan tray.
4. Power on the router and check the status LED on the front panel.
On means the fan tray is operating correctly. Off means the fan tray has failed the POST. For the
LED description of the fan tray, see "
Appendix C LEDs ."
Installing a CF card
To install a CF card on an MCP, remove the CF card cover first.
To install a CF card:
1. Push the CF card eject button all the way into the slot, and make sure the button does not project
from the panel.
2. Insert the CF card into the slot following the direction shown in Figure 20 , and make sure it does
not project from the slot.
Figure 20 Inserting the CF card into the slot
Installing a power module
The procedures for installing an AC power module and DC power module are the same. The following
uses a PSR650-A AC power module as an example.
1. Locate the slot to install the power module. Use even pressure to gently push the power module
slowly along the slide rails into the slot.
Figure 21 Inserting the power module into the slot
2. Fasten the captive screws on the power module with a Phillips screwdriver.
3. After connecting the power cord, power on the power module.