H3C Technologies H3C SR6600 - Manual (Page 28)

18
3. Use even pressure to gently push the FIP module into the slot along the slide rails until positioning
pins on the backplane are seated in the positioning holes, and then push the ejector levers inward
to lock the FIP module in position.
If you encounter a resistance when pushing a FIP module into slot, remove the filler panels at both
sides of the slot, install the FIP module, and then install the removed filler panels to prevent dust
from entering the chassis.
Figure 15 Inserting a FIP module
4. Fasten the captive screws on the FIP module clockwise with a Phillips screwdriver.
5. If the router is powered off, power it on.
After the FIP module is powered on, the RUN LED (green) flashes once and then flashes fast (at 8
Hz). It flashes slowly (at 1 Hz) after the application is loaded. This means that the FIP module runs
correctly. For more information about the FIP LEDs, see " Appendix C LEDs ."
Do not insert or remove a HIM/MIM into or from a FIP module when the RUN LED on the FIP is
flashing fast. Otherwise, an exception might occur.
Installing a SAP/OAP
SAPs are hot swappable and you must perform the remove slot number command to stop the module
before you remove it.
The procedures for installing a SAP module and OAP card are the same. The following uses a SAP
module as an example.
To install a SAP module:
1. Locate the slot to install the SAP module.
2. Remove the captive screws on the filler panel with a Phillips screwdriver.
3. Use even pressure to gently push the SAP module into the slot along the slide rails until positioning
pins on the backplane are seated in the positioning holes, and then push the ejector levers inward
to lock the SAP module in position.