H3C Technologies H3C SR6600 - Manual (Page 122)

112
Item Specification
Interface type Automatic MDI/MDI-X
Number of interfaces 1
Frame format
Ethernet_II
Ethernet_SNAP
Interface speed and duplex mode
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
Interface cable and maximum transmission distance
Category-5 twisted pair with a maximum transmission
distance of 100 m (328.08 ft)
Function
Used for router software upgrade and network
management
NOTE:
The media dependent interface (MDI) standard is typically used on the Ethernet port of network adapters.
The media dependent interface crossover (MDI-X) standard is typically used on hubs or LAN switches.
Combo interface
The MCP provides four combo interfaces.
Table 36 Copper Ethernet port specifications
Item Specification
Connector RJ-45
Interface type Automatic MDI/MDI-X
Frame format
Ethernet_II
Ethernet_SNAP
Interface speed and duplex mode
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
NOTE:
•
The media dependent interface (MDI) standard is typically used on the Ethernet port of network
adapters. The media dependent interface crossover (MDI-X) standard is typically used on hubs or LAN
switches.
• For a combo interface, you can use either the copper port or the fiber port. To switch between the copper
and fiber ports, use the combo enable { copper | fiber } command in interface view.
Table 37 Fiber Ethernet port specifications
Item Specification
Connector type LC
Transceiver module type SFP
Interface standards 802.3, 802.3u, and 802.3ab