H3C Technologies H3C SR6600 - Manual (Page 82)

72
3. Holding the ejector levers of the SAP module with both hands, pull the ejector levers outward, and
gently pull the SAP module out of the slot along the slide rails.
Figure 74 Pulling the SAP module out of the slot
4. If you do not install a new SAP module in the slot, install a blank panel. To install a new SAP
module, see "
Installing a SAP/OAP ."
Replacing a HIM
1. Determine the HIM to be removed. Use a flat-blade screwdriver to loosen the captive screws of the
HIM to be removed until all spring pressure is released.
2. Grasping the two ejector levers with both hands, pivot the ejector levers outward, and gently pull
the HIM out of the slot along the slide rails.
Figure 75 Pulling the HIM out of the slot