Configuring hwtacacs schemes – H3C Technologies H3C S12500-X Series Switches User Manual
Page 43

31
Step Command
Remarks
3.
Specify a security policy
server.
security-policy-server { ipv4-address
| ipv6 ipv6-address } [ vpn-instance
vpn-instance-name ]
By default, no security policy server
is specified for a scheme.
You can specify up to eight security
policy servers for a RADIUS scheme.
368B
Enabling SNMP notifications for RADIUS
When SNMP notifications are enabled for RADIUS, the SNMP agent supports the following notifications
generated by RADIUS:
•
RADIUS server unreachable notification—The RADIUS server cannot be reached. RADIUS
generates this notification if it cannot receive any response to an accounting or authentication
request within the specified RADIUS request transmission attempts.
•
RADIUS server reachable notification—The RADIUS server can be reached. RADIUS generates this
notification for a previously blocked RADIUS server after the quiet timer expires.
•
Excessive authentication failures notification—The number of authentication failures to the total
number of authentication attempts exceeds the specified threshold.
You can configure SNMP parameters to control the output of these SNMP notifications. For more
information, see Network Management and Monitoring Configuration Guide.
To enable SNMP notifications for RADIUS:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable SNMP notifications for
RADIUS.
snmp-agent trap enable radius
[ accounting-server-down |
authentication-error-threshold |
authentication-server-down |
accounting-server-up |
authentication-server-up ] *
By default, all types of SNMP
notifications are enabled for
RADIUS.
369B
Displaying and maintaining RADIUS
Execute display commands in any view and reset commands in user view.
Task Command
Display the RADIUS scheme
configuration.
display radius scheme [ radius-scheme-name ]
Display RADIUS packet statistics.
display radius statistics
Clear RADIUS statistics.
reset radius statistics
164B
Configuring HWTACACS schemes
370B
Configuration task list
Tasks at a glance
(Required.)
720H
Creating an HWTACACS scheme
- H3C S5560 Series Switches H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C S9800 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches