H3C Technologies H3C S12500-X Series Switches - Manual (Page 261)

249
word. Please enter your password.
old password:
new password:
confirm:
Updating user information. Please wait ... ...
…
# Display the current FIPS mode state.
display fips status
FIPS mode is enabled.
334B
Exiting FIPS mode through automatic reboot
557B
Networking requirements
A user has logged in to the device in FIPS mode through a console port.
Use the automatic reboot method to exit FIPS mode.
558B
Configuration procedure
# Disable FIPS mode.
[Sysname] undo fips mode enable
FIPS mode change requires a device reboot. Continue? [Y/N]:y
The system will create a new startup configuration file for non-FIPS mode and then reboot
automatically. Continue? [Y/N]:y
Waiting for reboot... After reboot, the device will enter non-FIPS mode.
559B
Verifying the configuration
After the device reboots, you can enter the system.
# Display the current FIPS mode state.
display fips status
FIPS mode is disabled.
335B
Exiting FIPS mode through manual reboot
560B
Networking requirements
A user has logged in to the device in FIPS mode through SSH with the username test and password
12345zxcvb!@#$%ZXCVB.
Use the manual reboot method to exit FIPS mode.
561B
Configuration procedure
# Disable FIPS mode.
[Sysname] undo fips mode enable
FIPS mode change requires a device reboot. Continue? [Y/N]:y
The system will create a new startup configuration file for non-FIPS mode, and then reboot
automatically. Continue? [Y/N]:n