H3C Technologies H3C S12500-X Series Switches - Manual (Page 226)

214
519B
Verifying the configuration
# Display dynamic IPv4 source guard binding entries obtained from DHCP snooping.
[Switch] display ip source binding dhcp-snooping
Total entries found: 1
IP Address MAC Address Interface VLAN Type
192.168.0.1 0001-0203-0406 XGE1/0/1 1 DHCP snooping
The output shows that IP source guard has generated a dynamic IPv4 source guard binding entry on
Ten-GigabitEthernet 1/0/1 based on the DHCP snooping entry.
296B
Dynamic IPv4 source guard using DHCP relay configuration
example
520B
Network requirements
As shown in
916H
Figure 66 , the host and the DHCP server are connected to the switch through interfaces
VLAN-interface 100 and VLAN-interface 200 respectively. DHCP relay is enabled on the switch. The host
obtains an IP address from the DHCP server through the DHCP relay agent.
Enable dynamic IPv4 source guard on VLAN-interface 100 to filter received packets based on the DHCP
relay entry generated on the switch.
Figure 66 Network diagram
521B
Configuration procedure
1. Configure dynamic IPv4 source guard:
# Configure IP addresses for the interfaces. (Details not shown.)
# Enable IPv4 source guard on VLAN-interface 100 to filter packets based on both the source IP
address and the MAC address.
system-view
[Switch] interface vlan-interface 100
[Switch-Vlan-interface100] ip verify source ip-address mac-address
[Switch-Vlan-interface100] quit
2. Configure the DHCP relay agent:
# Enable the DHCP service.
[Switch] dhcp enable
# Enable recording DHCP relay client entries.
[Switch] dhcp relay client-information record
# Configure VLAN-interface 100 to work in DHCP relay mode.
[Switch] interface vlan-interface 100
[Switch-Vlan-interface100] dhcp select relay
# Specify the IP address of the DHCP server.