H3C Technologies H3C S12500-X Series Switches - Manual (Page 211)

199
To establish a connection to the SFTP server:
a. Run the psftp.exe to launch the client interface shown in
903H
Figure 60 , and enter the following
command:
open 192.168.1.45
b. Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
Figure 60 SFTP client interface
286B
Publickey authentication enabled SFTP client configuration
example
506B
Network requirements
As shown in
904H
Figure 61 , you can log in to Switch B through the SFTP client that runs on Switch A and are
assigned the user role network-admin to execute file management and transfer operations. Switch B acts
as the SFTP server and uses publickey authentication and the RSA public key algorithm.
Figure 61 Network diagram
507B
Configuration procedure
In the server configuration, the client's host public key is required. Use the client software to generate the
RSA key pairs on the client before configuring the SFTP server.
1. Configure the SFTP client:
# Assign an IP address to VLAN-interface 2.
system-view