Configuring urpf, Network application – H3C Technologies H3C S12500-X Series Switches User Manual
Page 249

237
325B
Network application
Figure 77 Network diagram
Configure strict uRPF check between an ISP network and a customer network, and loose uRPF check
between ISPs.
143B
Configuring uRPF
When you configure uRPF, follow these restrictions and guidelines:
•
Global uRPF configuration takes effect on both IPv4 and IPv6 routes.
•
After you enable the uRPF feature on the switch, the routing table size might decrease by half on the
LPUs as follows:
{
IPv4 and IPv6 routes decrease by half on the following LPUs:
−
EA cards.
−
EB cards.
−
EC cards in the normal mode.
{
IPv6 routes decrease by half on EC cards that are in the extended routing mode.
For information about the operating mode of an LPU, see Fundamentals Configuration Guide.
•
If the number of routes exceeds half the routing table size of the switch, the uRPF feature cannot be
enabled. This mechanism avoids loss of routes and packets.
To enable uRPF globally:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
- H3C S5560 Series Switches H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C S9800 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches