Binding a source interface to an ipsec policy – H3C Technologies H3C S12500-X Series Switches User Manual
Page 204

192
Figure 56 Specifying the private key file
g.
Click Open to connect to the server.
If the connection is successfully established, the system asks you to enter the username. After
entering the username (client002), you can enter the CLI of the server.
283B
Password authentication enabled Stelnet client configuration
example
500B
Network requirements
As shown in
900H
Figure 57
, you can log in to Switch B through the Stelnet client that runs on Switch A and are
assigned the user role network-admin for configuration management. Switch B acts as the Stelnet server
and uses password authentication. The username and password of the client are saved on Switch B.
Figure 57 Network diagram
501B
Configuration procedure
1.
Configure the Stelnet server:
# Generate the RSA key pairs.
- H3C S5560 Series Switches H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C S9800 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches