Teac MX-2424 v1.15 - Manual (Page 87)

ViewNet MX
ViewNet MX Version 1.1/1.5 Owners Manual 87
Loop Record
Sets the behavior of the MX 2424 during Loop Record operation.
ƒ Auto Unload On/Off
With this setting on, the MX 2424 will create a new virtual track each time a record operation is
performed. This is done by unloading the track last recorded on before recording a new one. The MX
defaults to Auto Unload Off.
Pre-roll
Sets the amount of time before the In point (called the pre-roll amount) used for loop play and record
functions. The default value is 00:00:03:00
Post-roll
Sets the amount of time after the Out point (called the post-roll amount) used for loop play and record
functions. The default value is 00:00:02:00.
Tape Mode Start
TapeMode uses a start time as a basis for time stamping of recorded audio files. Set the TapeMode start
time using this setting. The default value is 01:00:00:00.
Tape Mode Length
TapeMode requires a defined project length. Set the TapeMode length using this setting. The default
value is 00:10:00:00.
Rollback Length
This is a setting you can use to define a “playhead jump”. Pressing the “,” key will move the transport
back by the value that you enter in this menu. Pressing the “.” key will advance the playhead forward by
the same amount. The default setting is 00:00:10:00.