Teac MX-2424 v1.15 - Manual (Page 64)

ViewNet MX
ViewNet MX Version 1.1/1.5 Owners Manual 64
Time Register Function Buttons
Some of the buttons in this section are used to perform operations on the value of the Entry Register and
other time registers. These are described here.
Capture
The Capture button is next to the Current button on the left side of the screen. Clicking on this button (or
the up arrow on your keyboard) will automatically copy the location of the playhead to the Entry
Register and prepare to store this value into the next selected user register.
Store
Clicking on Store (or the S key on your keyboard) will prepare to copy the value of the Entry Register
into the next selected user register. The Store button will flash while the store operation is pending. Click
on any register to complete the store operation or click again on the Store button to cancel the pending
store operation.
Locate
Clicking on Locate (or the L key on your keyboard) will automatically paste the value shown in the Entry
Register to the current playhead location. In other words, it will move the current location of the
playhead directly to the time value shown in the Entry Register. This value will then be shown in the
current display and be entered in the current time register.
Clear
Clicking Clear will set the value of the Entry Register to 0 (00:00:00:00 for timecode and 000000 00 for
feet-frames).
Read-Only Display Registers
Some registers may not be written into directly and serve as a read-only display of time information in
the Entry Register.