Teac MX-2424 v1.15 - Manual (Page 26)

ViewNet MX
ViewNet MX Version 1.1/1.5 Owners Manual 26
The Macintosh TCP/IP Window
From the TCP/IP window, select “Ethernet” in the box labeled “Connect Via.”
In the “Configure” box choose “Manually.”
Enter an appropriate IP address in the field provided. Please note that no two computers may
share an IP address, and that unpredictable behavior is likely to occur if they do. See the
discussion on IP addresses earlier in this chapter for more information.
Use the Subnet Mask field to enter the IP Net mask. Set this value to 255.255.255.000 unless your
network administrator advises that you should use a different setting.
If you plan to connect two networks or more then you must enter a Router IP address (Gateway address).
To specify a router IP address, move the cursor to Router Address box and enter the appropriate number.