Skutch Electronics BA-1000 V3.12 Technical Reference Manual - Manual (Page 33)

Version 3.12 Page 33
! Talk Pause= 20
This option tells the system how many seconds
of silence it needs in order to stop recording and
continue with the outgoing message. For this
option, 1 = .1 seconds. The display will look as
follows:
Talk Pause= 20
00 to 99 #=Next
Enter from 01 01 01 01 to 99 99 99 99 then press then
release # # # # to go to the next option. You can press
then release ~ ~ ~ ~ to return to the Total Calls
screen.
! Redial Pause= 00
This option tells the system the minimum
number of minutes that must expire, from the start of
the current dialing loop, before the system can start
the next redial loop. The display will look as
follows:
Redial Pause= 00
00 to 60 #=Next
Enter from 00 00 00 00 to 60 60 60 60 then press then
release # # # # to go to the next option. You can press
then release ~ ~ ~ ~ to return to the Total Calls
screen.
! Sense Level= 11
This option lets you manually set the sensitivity
level for the system’s answer detect. CAUTION:
This value should NOT be adjusted unless instructed
to by a Skutch Service Technician.
Sense Level= 11
01 to 20 #=Next
Enter the level from 01 01 01 01 to 20 20 20 20 then
press then release # # # # to go to return to the Total
Calls screen. You can press then release
~
~ ~ ~ to return to the Total Calls screen.
Remote
Operation
This version supports a simple remote
programming feature that lets you, optionally, record
a new “Play Only” message and make the system
call all of the phone numbers in file 9. This feature
is only intended for calling a customer base of
numbers, previously entered into file 9.
! Access Unit Remotely
The remote access will only be possible when
the system is at MENU, in Power Down state or at
End Of Session in dialing mode.
Call the unit.
The unit gives you a 2 tone beep after the 10
th
to 11 th ring.
Enter the Remote Access Code , then #; the
default is 0506, as follows:
0 5 0 6 #
The unit gives you a 3 tone beep, indicating
menu.
! Remote Record a Play
Only Message
At the remote menu (after the 3 tone beep),
enter:
8
When Long, Low tone stops, dictate your
message.
When finished, enter:
*
It will play it back and return to the remote
menu.
! Start Dialing File 9
At the remote menu (after the 3 tone beep),
enter:
3
The unit gives you two, 3 tone beeps, then 3
single beeps and hangs up. The system will restore