Skutch Electronics BA-1000 V3.12 Technical Reference Manual - Manual (Page 28)

Version 3.12 Page 28
Enter NEW String
Enter the new string followed by # # # #, and it
will show the following:
1=Add 2 nd String
3=Next option
Now you can press 1 1 1 1 to add a 2 nd string, up
to 16 digits, or press 3 3 3 3 to continue. You can press
then release ~ ~ ~ ~ to exit setup mode.
! Total Calls
This entry shows the master total phone calls
the system has processed. This can only be reset at
the factory. The display will look as follows:
- Total Calls -
----00000000----
You can press then release # # # # or ~ ~ ~ ~
to return to MENU. You can access the secondary
setup, while it shows the Total Calls, by entering:
*
* * *, * * * *, * * * *, * * * *, # # # #.
Secondary Setup
The secondary setup contains setting that
should only be changed by experienced users. It is
entered, from the
Total Calls window in * System
Setup, by entering: * * * *, * * * *, * * * *, * * * *, # # # #.
! Load APP Presets
This option allows you to reset the system back
to factory defaults or load the settings for a
predefined application. The display will look as
follows:
Load APP Presets
0 to 1 #=Next
You can press then release 0 0 0 0 to load the
defaults, 1 1 1 1 to load the Patient Reminder
application settings or # # # # to proceed to the next
option. You can press then release ~ ~ ~ ~ to
return to the Total Calls screen.
Factory Defaults
The display will show the following:
Load APP Presets
0 to 1 #=Next
Press then release 0 0 0 0 and it will show the
following for 2 seconds:
Loading Defaults
- Please Wait –
The system will then show the following:
Load APP Presets
0 to 1 #=Next
Load Application 1
The display will show the following:
Load APP Presets
0 to 1 #=Next
Press then release 1 1 1 1 and it will show the
following for 2 seconds:
Loading APP # 1
– Please Wait -
The system will then show the following:
Load APP Presets
0 to 1 #=Next
! Remote Code= 0506
This option allows you to change the access
code used in Remote Mode. The display looks as
follows:
Remote Code=0506
1=Change #=Next
Press then release 1 1 1 1 to let you change this
code, then enter the new code followed by # # # #;
press then release # # # # to go to the next option. You