Skutch Electronics BA-1000 V3.12 Technical Reference Manual - Manual (Page 14)

Version 3.12 Page 14
enter this mode press then release ~ ~ ~ ~, it
will show the following:
0-Menu-Ver 3.10A
11/01/01 08:00am
Enter: 5 5 5 5 then # # # # and it will show the
following:
1=Format Disk
3=Next Option
! Format Disk
This screen lets you format a ZIP 100 disk to
prepare it for usage in the system. You can press
then release
1 1 1 1 to Format the ZIP disk, or 3 3 3 3 to
go to the next screen.
Quick Format
If you press then release 1 1 1 1, it will show the
following:
1=Quick Format
3=Full Format
You can press then release 1 1 1 1 to quick format
(reset the basic file structure, about 3 seconds) or
3
3 3 3 to fully format (erase and initialize the entire
disk surface, about 10 minutes). If you press then
release
1 1 1 1 for quick formatting, it will show the
following:
Formatting Disk
- Please Wait –
When the formatting is totally finished, the
display will show:
Format Complete
--- Press # ---
When you press then release # # # #, the system
will go through the initial diagnostic testing, and test
the newly prepared disk, then return you to the
MENU.
Full Format
If you press then release 3 3 3 3, it will show the
following:
Formatting Disk
- 00% Complete –
When the formatting completes, it will show
the following:
Formatting Disk
- Please Wait –
When the formatting is totally finished, the
display will show:
Format Complete
--- Press # ---
When you press then release # # # #, the system
will go through the initial diagnostic testing, and test
the newly prepared disk, then return you to the
MENU.
! Copy Prompts
This screen lets you copy the outgoing message
and TAD prompts from one disk to another disk; it
will show the following:
1=Copy Prompts
3=Next Option
NOTE: Make sure you have already formatted
the COPY ZIP disk (See Prepare to Copy ). You can
press then release 1 1 1 1 to copy the prompts, or 3 3 3 3
to go to the next screen.
If you press then release 1 1 1 1, it will show the
following:
Put COPY into
-- Zip Drive—
Now take that MASTER disk out and insert the
COPY disk. After some initial setup, it will show
the following:
Put MASTER into
-- Zip Drive—
Now take the COPY disk out and put
(MASTER disk back in and keep swapping disks, as
indicated, until it finishes copying.