Skutch Electronics BA-1000 V3.12 Technical Reference Manual - Manual (Page 25)

Version 3.12 Page 25
button to advance to the next option, or you can
change the option and then press then release
# # # # to
proceed. You can use ~ ~ ~ ~ to back out/exit
this mode at any time.
! Change The Time/Date
The first option in System Setup is to set the
current time. The display will show the following:
Set CURRENT Time
1=Change #=Next
You can press then release 1 1 1 1 to change the
current time or # # # # to proceed to the next option.
You can press then release ~ ~ ~ ~ to exit
setup mode.
Set The Current Day
If you press then release 1 1 1 1 to change the
time; the display shows:
Enter day, 1 – 7
#=Sunday
The current day will be shown in the bottom of
the display. To change the day, press then release
the corresponding number followed by
# # # #; i.e. 1 1 1 1
for Sunday, 2 2 2 2 for Monday, etc.
Set The Current Date
Now the display will show:
-- Enter Date –-
# = 01/01/1980
The current date will appear in the bottom of
the display. You can enter a new date followed by
#
# # #, or just press then release # # # # to keep the
current date.
Set the Current Time
Now the display will show:
-- Enter time --
- # = 12:00 pm –
The current time will appear in the bottom of
the display. You can enter a new time followed by
# # # #, or just press then release # # # # to keep the
current time. You can change between a.m./p.m. by
pressing then releasing the
* * * *.
! Set The Dial Times
This option allows you to set the starting and
stopping dialing times for each day of the week; the
display will look as follows:
Set DIALING Time
1=Change #=Next
You can press then release 1 1 1 1 to change the
dialing times or # # # # to proceed to the next option.
You can press then release ~ ~ ~ ~ to exit
setup mode.
Select The Day To Change
Press then release 1 1 1 1 to change the time; the
display shows:
Enter day, 1 – 7
#=Sunday
To change the dialing times for a day, press
then release the corresponding number followed
#
# # #; i.e. 1 1 1 1 for Sunday, 2 2 2 2 for Monday, etc.
Set The Start Time
Now the display will show:
Enter START Time
- # = 09:00 am –
Now you can enter a new start time followed by
# # # #, or just press then release # # # # to keep the
current time. You cannot enter a time earlier than
9:00 a.m. You can change between a.m./p.m. by
pressing then releasing the
* * * *.
Set The Stop Time
Now the display will show:
Enter STOP Time
- # = 09:00 pm –
Now you can enter a new stop time followed by
# # # #, or just press then release # # # # to keep the