Skutch Electronics BA-1000 V3.12 Technical Reference Manual - Manual (Page 32)

Version 3.12 Page 32
Press then release 1 1 1 1 to toggle between On
and Off; press then release # # # # to go to the next
option. You can press then release ~ ~ ~ ~ to
return to the Total Calls screen.
! 6pm Redials= Off
This option allows you to enable the 6p.m.
redial feature. This feature will make the system
stop the current dialing at 6p.m., and start calling
from the beginning (only No Answers and Busies).
The display will look as follows:
6pm Redial= Off
1=Change #=Next
Press then release 1 1 1 1 to toggle between On
and Off; press then release # # # # to go to the next
option. You can press then release ~ ~ ~ ~ to
return to the Total Calls screen.
! Post Pound= Off
This option allows you to enable automatic
dialing of a touch tone # # # # after it dials each phone
number. This feature is used when using certain
long distance calling plans. The display will look as
follows:
Post Pound= Off
1=Change #=Next
Press then release 1 1 1 1 to toggle between On
and Off; press then release # # # # to go to the next
option. You can press then release ~ ~ ~ ~ to
return to the Total Calls screen.
! TAD Hangup= Off
This option allows you to force the system to
hang up the instant it detects an answering machine.
TAD Hangup= Off
1=Change #=Next
Press then release 1 1 1 1 to toggle between On
and Off; press then release # # # # to go to the next
option. You can press then release ~ ~ ~ ~ to
return to the Total Calls screen.
! No Ans Rings= 5
This option allows you to set the number of
rings the system accepts, before it considers the call
a No Answer.
No Ans Rings= 5
1 to 9 #=Next
Enter from 1 1 1 1 to 9 9 9 9 to choose from 1 to 9
rings before the call becomes a No Answer, then
press then release
# # # # to go the next option. You
can press then release ~ ~ ~ ~ to return to the
Total Calls screen.
! Hello Pause= 05
This option lets you change the amount of
silence needed, to activate the message, after
someone says “Hello”. CAUTION: This value
should NOT be adjusted unless instructed to by a
Skutch Service Technician. For this option, 1 = .1
seconds. The display will look as follows:
Hello Pause= 05
05 to 15 #=Next
Enter the level from 05 05 05 05 to 15 15 15 15 then
press then release # # # # to go to the next option. You
can press then release ~ ~ ~ ~ to return to the
Total Calls screen.
! Dial Pause = 02
This option lets you change the number of
seconds the unit pauses between each phone number.
For this option, 1 = 1 second. The display will look
as follows:
Dial Pause= 02
02 to 30 #=Next
Enter the level from 02 02 02 02 to 30 30 30 30 then
press then release # # # # to go to the next option. You
can press then release ~ ~ ~ ~ to return to the
Total Calls screen.