Skutch Electronics BA-1000 V3.12 Technical Reference Manual - Manual (Page 13)

Version 3.12 Page 13
0-Entry> 00000 C
----- Lead -----
Once the system has paused, it will show the
following:
Paused-Continue?
1=Yes 3=No
Now you can release the # # # # button. You can
leave the system like this until you are ready to
continue dialing, then just press then release
1 1 1 1
and the system will pick up where it left off; or you
can press then release
3 3 3 3 or ~ ~ ~ ~ to return
to the MENU.
! End Of Session
When the system reaches the end of all the
dialing, it will return to the MENU.
! Manual Call Abort
You can force the system to abort the current
call by pressing then releasing 5 5 5 5; the system will
indicate the call is a hang up.
! Volume Control
The volume on the BA-1000 can be increased
by multiple pressing then releasing of the 9 9 9 9
button. You can decrease the volume by multiple
pressing then releasing of the
7 7 7 7 button. At min
volume, the speaker is completely off and trying to
go lower does nothing. At max volume, trying to go
higher does nothing. The volume control only
adjusts the volume you hear over the speaker, not
what the called party hears, and it only adjusts the
volume for Dial File and Order Taking modes.
NOTE: This volume can only be adjusted while
the system is: waiting for an answer, playing the
message or listening/recording user input, during
a dial session.
4 Select File
This mode is used to select the dialing file to
use/edit and to enter the default area code and other
local area codes. To enter this mode press then
release
~ ~ ~ ~, it will show the following:
0-Menu-Ver 3.10A
11/01/01 08:00am
Enter: 4 4 4 4 then # # # # and it will show the
following:
Current File = 0
#=Next 0-9 or *
! Dial File Select
You can select a different file for number
entry/editing by entering a number from 0 0 0 0 to 9 9 9 9
followed by # # # #. The default dialing file is 0. If
you press then release * * * *, you will select the DO
NOT DIAL file, and the display will show an N for
the file number in the top right, as shown below:
Current File = N
#=Next 0-9 or *
If you select the DO NOT DIAL file, you can
edit/add/delete it, but you will not be allowed to
enter a dialing session with it. You can exit by
pressing then releasing
~ ~ ~ ~ or continue by
pressing then releasing # # # #.
! Area Code Entry
After pressing then releasing # # # #, you will be
at the local area code screen as follows:
Enter Local Area
Code, # =
You MUST enter the area code the system will
be calling from, then # # # #. You can enter * * * * then
# # # # to remove an area code.
5 Disk Tools
The BA-1000 offers several basic disk utilities
for setting up the ZIP disk and copying files. To