RLE Wi-MGR V.1.6 - Manual (Page 62)

62 Wi-MGR User Guide 800.518.1519
4
4.1.1.3 Data Field
The data field of the request is a variable length depending on the function. The data fields for
the Wi-MGR are 16-bit registers, transmitted high order byte first (big-endian)
4.1.1.4 Error Check (Checksum) Field
The checksum field lets the receiving device determine if the packet has transmission errors.
The Wi-MGR’s RTU mode uses a 16-bit cyclic redundancy check (CRC-16).
4.1.2 Exception Responses
If a Modbus master sends an invalid command to the Wi-MGR or attempts to read an invalid
register, an exception response is generated. The response packet will have the high order bit
of the function code set to one. The data field of the exception response contains the exception
error code.
4.2. Packet Communications for the Wi-MGR
This section outlines the registers with the name and a brief description of each.
4.2.1 Function 03: Read Output Registers
To read the Wi-MGR’s parameter values, the master must send a Read Output Registers
request packet.
The Read Output Registers request packet specifies a start register and the number of registers
to read. The start register is numbered from zero (40001 = zero, 40002 = one, etc.).
Code Name Description
01 Illegal Function The function code is not supported
02 Illegal Data Address Attempt to access an invalid address
03 Illegal Data Value Attempt to set a variable to an invalid value
Table 4.1 Exception Codes
Read Registers Request Packet Read Registers Response Packet
Slave Address (1 byte) Slave Address (1 byte)
03 (Function code) (1 byte) 03 (Function code) (1 byte)
Start Register (2 bytes) Byte count (1 byte)
# of registers to read (2 bytes) First register (2 bytes)
Crc Checksum (2 bytes) Second register (2 bytes)
…
Crc Checksum (2 bytes)
Table 4.2 Read Output Registers Packet Structure