RLE Wi-MGR V.1.6 - Manual (Page 20)

20 Wi-MGR User Guide 800.815.1519
2 Getting Started
2.5. Sensor Discovery
The Wi-MGR is equipped with a sensor discovery feature. The device will discover available
wireless sensor inputs and enter them into the Sensor Summary page. By default, this feature
is disabled. Turn on this feature when you are installing or locating new sensors. Turn it off
once your sensors have all been discovered. If you do not turn off the Sensor Discovery
feature, the Wi-MGR will continue to attempt to find new sensors. This could cause a device
malfunction, or contaminate your list of active sensors with additional sensors that do not
actually exist.
To configure sensors to communicate with the Wi-MGR, follow these steps:
1 In the Wi-MGR’s user interface, go to the Configuration>Wireless/Sensors page. If it is not
already enabled, click the Enabled radio button for Sensor Discovery. Click the Submit
Changes button to save the modification and enable the sensor discovery.
Figure 2.9 Enabling Sensor Discovery
2 Take off the sensor’s lid by pinching the outer corners of the lid.
Figure 2.10 Remove the Sensor’s Lid
3 With the lid off, remove the polyester tab from the battery. Make sure the terminal clips fit
snugly around the battery (if necessary, gently squeeze them to tighten the contacts) and
make sure the terminal clips and ends of the battery are free of any glue residue that may