RLE Wi-MGR V.1.6 - Manual (Page 23)

rletech.com Wi-MGR User Guide 23
2 Getting Started
remain visible. The serial number on this label is unique to each sensor, and you will need to
refer to this number throughout the life span of the sensor.
Figure 2.15 Magnetic Strips Used to Mount a Sensor
To mount sensors using magnetic tape:
1 For each sensor, cut two 1.5-inch (3.81cm) strips of tape.
Figure 2.16 Recommended Length of 0.5 Inch for Magnetic Strip
2 Make sure the back of the sensor is clean. If necessary, use isopropyl alcohol to clean the
sensor.
3 Remove the protective film from the adhesive side of the magnetic tape and place the tape
on the sensor.
4 Place the sensor in the desired location.