RLE LD5000 - Manual (Page 31)

User Guide: LD5000 Chapter 9: RS-232 Interface Startup
www.rletech.com 970.484.6510 23
CHAPTER 9: RS-232 INTERFACE STARTUP
Make sure the RS-232 port is connected to a PC or terminal with a straight through cable (see section 2-6
RS-232 Connector on page 6). Run terminal emulation software and make sure the settings match the
LD5000 RS-232 port configuration. When the LD5000 is powered up, diagnostics are performed. The
boot ROM and flash program code are verified. Output similar to the screen displayed below should
appear on the terminal or terminal emulation software. Once the system reaches this point, press the Enter
(
↵) key to display the Main Menu.
RLEbh Firmware V1.1 BOOTUP - THU 03/06/03 10:58:24
uP last reset by: external signal
Diagnostics in progress
Serials: Passed
Ram: Passed
Clock: Passed
VPP = 5.04 Passed
Flash Blank Check:
Parm1= Has Data
Parm2= Has Data
Prgm = Has Data
Prgm Flash checksum: 6C32/6C32 Valid
Power Supplies:
24V: 22.66
15V: 15.17
Passed
Flash Code will start in 5 seconds
Press any key to abort Flash Code
LD5000 V2.3 B0 03/06/03
SYSTEM BOOTED @ 03/06/03 10:58:32
Copyright 2003, Raymond & Lae Engineering Inc.
Loading Block 2
DATA LOADED
LD5000 Diagnostics
Initializing Cable ADC: Passed