Switches, Sw1: setting rs-485 address, Sw2: baud rate settings, lcd display, 4-20ma scale – RLE LD5000 User Manual
Page 15
User Guide: LD5000
Chapter 2: Connections and Settings
www.rletech.com 970.484.6510
7
Figure 2-2 LD5000 Wiring Diagram
2-7
SWITCHES
2-7.1 SW1: Setting RS-485 Address
8 7 6 5 4 3 2 1
SW1, positions 1 through 8, are used to set the RS-485 address. The
address can range from 00000001 to 11111111.
2-7.2 SW2: Baud Rate Settings, LCD Display, 4-20mA Scale
8 7 6 5 4 3 2 1
For All SW Settings:
1 – Switch is on.
0 – Switch is off.
See also other documents in the category RLE Equipment:
- LD2000 Quick Start (2 pages)
- LD300 (2 pages)
- LDZ4 (19 pages)
- LD2000 (78 pages)
- LD5100 Quick Start (2 pages)
- LD310 (2 pages)
- LD5000 Quick Start (4 pages)
- LD1000 (2 pages)
- LD5100 (72 pages)
- 10K Quick Start (2 pages)
- F200 (2 pages)
- LDRA6 Quick Start (2 pages)
- 10K V.2.5.a (44 pages)
- LD1500 Quick Start (2 pages)
- LD2100 Quick Start (2 pages)
- LD5200 Quick Start (2 pages)
- LD1500 V.3.1 (52 pages)
- FDS-Wi Quick Start (2 pages)
- GD100 (26 pages)
- FDS-Wi V.2.5 (74 pages)
- LD2100 V.2.6 (92 pages)
- LD5200 V.2.3 (118 pages)
- F-Series Quick Start (2 pages)
- F110 Quick Start (2 pages)
- Wi-MGR Quick Start (2 pages)
- Wi-MGR V.1.6 (74 pages)
- FMS Quick Start (2 pages)
- FMS32 (92 pages)
- Ground Fault Monitor (2 pages)
- RA1x2 (2 pages)
- Protocol Converter Quick Start (2 pages)
- Protocol Converter V.2.4 (70 pages)
- Falcon EM (146 pages)
- FMS V.1.13 (226 pages)